Registreeru, et avada oma eksklusiivsed B2B hinnad ja alustada ostlemist. Registreeru kohe!
Switching relay, 1 CO contact 16A image 1
ELTAKO

Switching relay, 1 CO contact 16A

Laos: Ei Hankija laovaru: Ei Minimaalne tellimuse kogus: 1
Hind (ilma KM-ta):
36,50 €
Hind kehtib kuni 31.12.24
EAN: 4010312205365
MPN: 22001601
Pakend: 1

Technical Information

Toote seisukord Uus
Tootja nimi Switching relay, 1 CO contact 16A
Bränd ELTAKO
Kategooriad Releed
Päritoluriik CN
Harmoneeritud süsteemi kood 8536 4900 00
Paigaldusviis DIN liist
Funktsioon Osaliselt elektrooniline
Sisseehitussügavus 58 mm
Tunnusvool 16 A
Laius mooduli arvudes 1
Juhtpinge 1 230-8 V
Juhtpinge 1 liik AC/DC
Juhtpinge 1 sagedus 50 Hz
Toitepinge liik AC
Toitepinge 250 V
Suurim lülitusvool (cos phi = 0.6) 4 A
Suurim hõõglampide koormus 2000 W
Suurim luminofoorlampide koormus 1000 VA
Suurim luminofoorlampide koormus (kaks ahelat) 1000 VA
Suurim luminofoorlampide koormus (rööpkompensatsiooniga) 500 VA
Normaalselt suletud kontaktide arv 0
Normaalselt avatud kontaktide arv 0
Ümberlülituskontaktide arv 1

Pakendamise üksikasjad

Pakkimistase 1 4010312205365, 4010312205365
Pakkimistase 2 4010312205365
Pakkimistase 3 4010312205365

Allalaadimised

Toote lehe süvalink

Kirjeldus

1 CO contact potential free 16A/250V AC. 230V LED lamps up to 200W, incandescent lamp load 2000W. No standby loss. Modular device for DIN-EN 60715 TH35 rail mounting. 1 module = 18mm wide, 58mm deep. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. Universal control voltage 8 to 230V UC. Low control power demand, therefore substantially less heat is generated. Integrated free-wheeling anti-surge diode (A1 = +, A2 = -). Safe disconnection to VDE 0106, Part 101. Therefore, these devices can also be used as coupling relays. By using a bistable relay coil power loss and heating is avoided even in the on mode. The relay contact can be open or closed when putting into operation. It will be synchronised at first operation. This relay is not suitable to feed back the switching voltage signal of a dimmer switch. Use only relays ESR12DDX-UC, ESR12NP-230V+UC or ESR61NP-230V+UC for this purpose. The electronics does not have an internal power supply and therefore no standby loss. The microcontroller is activated when the control contact closes. This switches the bistable relay to the correct direction. The bistable relay switches back either when the control contact opens or when the control voltage falls.