Registreeru, et avada oma eksklusiivsed B2B hinnad ja alustada ostlemist. Registreeru kohe!
Switching relay, 1 NO contact 16 A
Laos: Ei
Hankija laovaru: Ei
Minimaalne tellimuse kogus: 1
Hind (ilma KM-ta):
36,57 €
EAN: 4010312205402
MPN: 22100002
Pakend: 1
Technical Information
| Toote seisukord | Uus |
| Tootja nimi | Switching relay, 1 NO contact 16 A |
| Bränd | ELTAKO |
| Kategooriad |
Releed
|
| Päritoluriik | CN |
| Harmoneeritud süsteemi kood | 8536 4900 00 |
| Paigaldusviis | DIN liist |
| Funktsioon | Osaliselt elektrooniline |
| Sisseehitussügavus | 58 mm |
| Tunnusvool | 16 A |
| Laius mooduli arvudes | 1 |
| Juhtpinge 1 | 8-230 V |
| Juhtpinge 1 liik | AC/DC |
| Juhtpinge 1 sagedus | 50 Hz |
| Toitepinge liik | AC |
| Toitepinge | 250 V |
| Suurim lülitusvool (cos phi = 0.6) | 4 A |
| Suurim hõõglampide koormus | 2000 W |
| Suurim luminofoorlampide koormus | 1000 VA |
| Suurim luminofoorlampide koormus (kaks ahelat) | 1000 VA |
| Suurim luminofoorlampide koormus (rööpkompensatsiooniga) | 500 VA |
| Normaalselt suletud kontaktide arv | 0 |
| Normaalselt avatud kontaktide arv | 1 |
| Ümberlülituskontaktide arv | 0 |
Pakendamise üksikasjad
| Pakkimistase 1 | 4010312205402, 4010312205402 |
| Pakkimistase 2 | 4010312205402 |
| Pakkimistase 3 | 4010312205402 |
Allalaadimised
Kirjeldus
Switching relay. No standby loss. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. Simply connect the neutral conductor to the terminal (N) and L to 1(L) for this. This gives an standby consumption of only 0.1 Watt. If the contact is used for controlling switching devices which do not perform zero passage switching themselves, (N) should not be connected because the additional closing delay otherwise causes the opposite effect. Very low switching noise. Contact position indicator with LED. Same terminal connection as electromechanical switching relay R12-100-. By using a bistable relay coil power loss and heating is avoided even in the on mode. The relay contact can be open or closed when putting into operation. It will be synchronised at first operation. This relay is not suitable to feed back the switching voltage signal of a dimmer switch. The electronics does not have an internal power supply and therefore no standby loss. The microcontroller is activated when the control contact closes. This switches the bistable relay to the correct direction. The bistable relay switches back either when the control contact opens or when the control voltage falls.