Registreeru, et avada oma eksklusiivsed B2B hinnad ja alustada ostlemist. Registreeru kohe!
Wireless 4-way universal transmitter module image 1
ELTAKO

Wireless 4-way universal transmitter module

Laos: Ei Hankija laovaru: Ei Minimaalne tellimuse kogus: 1
Hind (ilma KM-ta):
59,13 €
Hind kehtib kuni 31.12.24
EAN: 4010312321386
MPN: 30000301
Pakend: 1

Technical Information

Toote seisukord Uus
Tootja nimi Wireless 4-way universal transmitter module
Bränd ELTAKO
Kategooriad Lülitid
Päritoluriik CN
Harmoneeritud süsteemi kood 8526 9200 00
Toide Muul viisil
Edastuskaugus 30 m
Muutuva koodisüsteemiga No
Käskude arv 4
Süvistatud paigaldusega raadiosaatja No
Pindpaigaldusega raadiosaatja No
Klahvistiku kaitsekattega No
Raadiosagedus 868 MHz
Käsiraadiosaatja No
Raadiosignaali kodeerimisseade No
Kaitseaste (IP) IP20

Pakendamise üksikasjad

Pakkimistase 1 4010312321386, 4010312321386
Pakkimistase 2 4010312321386
Pakkimistase 3 4010312321386

Allalaadimised

Toote lehe süvalink

Kirjeldus

Wireless 4-way universal transmitter module. With internal antenna. With battery (lifetime 5-8 years). For installation. 45mm long, 45mm wide, 18mm deep. This transmitter module has four channels to transmit wireless telegrams to the Eltako Wireless Building system like a 4-channel wireless pushbutton. E1 initiates a wireless telegram such as Press top rocker of a wireless pushbutton with a rocker. E2 initiates Press bottom rocker (or right rocker of a wireless pushbutton with double rocker in each case). E3 initiates like Press left top rocker of a wireless pushbutton with a double rocker and E4 initiates like Press left bottom rocker of a wireless pushbutton with a double rocker. When the control contacts are opened, the telegram is the same as Release wireless pushbutton. The control inputs can be activated by internally placed jumpers either for pushbuttons (as-delivered state), window/door contacts or motion detectors. With a cable length up to 10 metres, conventional pushbuttons, window/door contacts or floating motion detector contacts can be connected to terminals E1, E2, E3 and E4. The opposite pole in each case is GND. The electronics is powered by an internal button cell CR2032. To replace the battery or activate battery supply, open the housing and remove an insulation strip. The housing must also be opened to select the modes. To open the housing, use a screwdriver to release the tabs on the lid and then remove the lid.