Staircase time switch, 1 NO contact 10A

Toote seisukord	Uus
Tootja nimi	Staircase time switch, 1 NO contact 10A
Bränd	ELTAKO
Kategooriad	Releed
Päritoluriik	CN
Harmoneeritud süsteemi kood	8536 5080 00
Paigaldusviis	Süvistatud paigaldus (krohvi)
Funktsioon	Elektrooniline väljalülitamise eelhoiatusega
Sisseehitussügavus	18 mm
Vabastusviivitus	1-12 min
Laius mooduli arvudes	0
Juhtpinge 1	230 V
Juhtpinge 2	8-230 V
Juhtpinge 1 liik	AC
Juhtpinge 2 liik	AC/DC
Juhtpinge 1 sagedus	50 Hz
Juhistikusüsteem	3 ja 4 juhtmega konfiguratsioon
Väljalülitamise eelhoiatus	Vilkumine
Korduv	Korduv + pidevvalgus + ajapikendus
Toitepinge liik	AC
Toitepinge	250 V
Suurim hõõglampide koormus	2000 W
Suurim luminofoorlampide koormus	1000 VA
Suurim luminofoorlampide koormus (kaks ahelat)	1000 VA
Suurim luminofoorlampide koormus (rööpkompensatsiooniga)	500 VA
Tunnuslülitusvool	10 A
Nupplüliti gaaslahenduslambi vool	50 mA
Voolu impulssfunktsioon on valitav	No
Normaalselt suletud kontaktide arv	0
Normaalselt avatud kontaktide arv	1
Ümberlülituskontaktide arv	0
Max. switching power LED	200 W

Pakkimistase 1	4010312400739, 4010312400739
Pakkimistase 2	4010312400739
Pakkimistase 3	4010312400739

1 NO contact not potential free 10A/250V AC. 230 V LED lamps up to 600W, energy saving lamps ESL up to 200W, incandescent lamps up to 2000W. Switch-off early warning and permanent light by pushbutton switchable. Standby loss 0.7 watt only. With ESL optimisation. Built-in device for installation. 45mm long, 45mm wide, 18mm deep. Zero passage switching to protect contacts and lamps. By using a bistable relay coil power loss and heating is avoided even in the on mode. The switched consumer may not be connected to the mains before the short automatic synchronisation after installation has terminated. Control voltage, supply voltage and switching voltage 230V. In addition electrically isolated universal voltage from 8 to 230V UC. With infinitely variable time range from 1 to 12 minutes. 50mA glow lamp current, dependent on the ignition voltage of the glow lamps. 3-wire and 4-wire circuits, resettable, with attic lighting if 4-wire circuit. Automatic detection of the method of connection. After a power failure the lighting is switched on again in case the set time has not elapsed yet. If switch-off early warning function is switched on, the light starts flickering approx. 30 seconds before time-out and is repeated three times at decreasing time intervals. If permanent light by pushbutton is switched on, permanent light can be switched on by pressing the pushbutton longer than 1 second. This is switched off automatically after 60 minutes or by pressing the pushbutton longer than 2 seconds. If both switch-off early warning function and permanent light by pushbutton   are switched on, the switch-off early warning function is activated before the permanent light switches off. When energy saving lamps ESL are completely or partially switched, then set the switch-off early warning with the pushbutton permanent light ESL on the lower rotary switch. If the function TLZ is selected the time can be extended within the first second after switching on or resetting by pressing the pushbutton repeatedly up to three times (incrementing). Each momentary-contact control increments the set time once. The function ESV, impulse switch with release delay up to 120 minutes, can be selected ­optionally. If this function is set it is automatically disconnected after the set delay is timed out if a manual OFF command has not been given. If the timing period is set to minimum in the function ESV, the release delay is switched off. The standard impulse switch function ES is then set.