Registreeru, et avada oma eksklusiivsed B2B hinnad ja alustada ostlemist. Registreeru kohe!
Isolating relay with window contact, 1 NO contact 10A image 1
ELTAKO

Isolating relay with window contact, 1 NO contact 10A

Laos: Ei Hankija laovaru: Ei Minimaalne tellimuse kogus: 1
Hind (ilma KM-ta):
50,30 €
Hind kehtib kuni 31.12.24
EAN: 4010312205495
MPN: 61100631
Pakend: 1

Technical Information

Toote seisukord Uus
Tootja nimi Isolating relay with window contact, 1 NO contact 10A
Bränd ELTAKO
Kategooriad Juhtimisseadmed lülitite ja pistikupesade jaoks
Päritoluriik CN
Harmoneeritud süsteemi kood 8536 4900 00
Nimipinge 230 V
Paigaldusviis Muul viisil
Sagedus 50 Hz
Ühendatavate mootorite arv 1
Alajaama sisend No
Kesksisend Yes

Pakendamise üksikasjad

Pakkimistase 1 4010312205495, 4010312205495
Pakkimistase 2 4010312205495
Pakkimistase 3 4010312205495

Allalaadimised

Toote lehe süvalink

Kirjeldus

1 NO contact not potential free 10A/250V AC. 230V LED lamps up to 100W, incandescent lamp load 2000W. With window contact. Standby loss 0.5 watt only. For installation. 45mm long, 45mm wide, 18mm deep. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. Control input with internally produced low voltage 24V DC. With an isolating transformer electrically isolated from power supply and make contact (PELV). Therefore no external low voltage power supply necessary. With 2 L terminals and 2 N terminals for an easy and quick installation. Power supply 230V. The enclosed window contact consists of a Reed relay with terminals and a solenoid. The NC contact opens when the solenoid approaches closer than 25mm. The disconnection relay ETR61NP is connected to terminals T1 and T2. Power supply to the extractor only cuts in when the window is open. ETR61NP can be wired in the flush mounted socket behind the socket for the extractor. Mounting the window contact FK: Lever out the inserts at the narrow end of the housing. Wire up the Reed relay and cut out the cable entry on the housing. Affix the two housings in parallel maximum 15mm apart and also screw if necessary. In the longitudinal direction the solenoid may be twisted in any direction compared to the Reed relay.