Reģistrējieties, lai atbloķētu savas ekskluzīvās B2B cenas un sāktu iepirkties. Reģistrējieties tagad!
Isolating relay with window contact, 1 NO contact 10A image 1
ELTAKO

Isolating relay with window contact, 1 NO contact 10A

Ir noliktavā: Nē Piegādātāja krājumi: Nē Minimālais pasūtījuma daudzums: 1
Cena (bez PVN):
50,30 €
Šī cena ir spēkā līdz 31.12.24
EAN: 4010312205495
MPN: 61100631
Iepakojums: 1

Technical Information

Preces stāvoklis Jauns
Ražotāja nosaukums Isolating relay with window contact, 1 NO contact 10A
Zīmols ELTAKO
Kategorijas Vadības ierīces slēdžiem un rozetēm
Izcelsmes valsts CN
Harmonizētās sistēmas kods 8536 4900 00
Nominālais spriegums 230 V
Montāžas metode Citi
Biežums 50 Hz
Savienojamo motoru skaits 1
Apakšstacijas ieeja No
Centrālā ievade Yes

Iepakojuma informācija

Iepakojuma līmenis 1 4010312205495, 4010312205495
Iepakojuma līmenis 2 4010312205495
Iepakojuma līmenis 3 4010312205495

Lejupielādes

Links uz ražotāju mājaslapu

Apraksts

1 NO contact not potential free 10A/250V AC. 230V LED lamps up to 100W, incandescent lamp load 2000W. With window contact. Standby loss 0.5 watt only. For installation. 45mm long, 45mm wide, 18mm deep. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. Control input with internally produced low voltage 24V DC. With an isolating transformer electrically isolated from power supply and make contact (PELV). Therefore no external low voltage power supply necessary. With 2 L terminals and 2 N terminals for an easy and quick installation. Power supply 230V. The enclosed window contact consists of a Reed relay with terminals and a solenoid. The NC contact opens when the solenoid approaches closer than 25mm. The disconnection relay ETR61NP is connected to terminals T1 and T2. Power supply to the extractor only cuts in when the window is open. ETR61NP can be wired in the flush mounted socket behind the socket for the extractor. Mounting the window contact FK: Lever out the inserts at the narrow end of the housing. Wire up the Reed relay and cut out the cable entry on the housing. Affix the two housings in parallel maximum 15mm apart and also screw if necessary. In the longitudinal direction the solenoid may be twisted in any direction compared to the Reed relay.