Registreeru, et avada oma eksklusiivsed B2B hinnad ja alustada ostlemist. Registreeru kohe!
Bus pushbutton coupler for 8 conventional pushbuttons image 1
ELTAKO

Bus pushbutton coupler for 8 conventional pushbuttons

Laos: Ei Hankija laovaru: Ei Minimaalne tellimuse kogus: 1
Hind (ilma KM-ta):
76,58 €
Hind kehtib kuni 31.12.24
EAN: 4010312326015
MPN: 30014075
Pakend: 1

Technical Information

Toote seisukord Uus
Tootja nimi Bus pushbutton coupler for 8 conventional pushbuttons
Bränd ELTAKO
Kategooriad Andurid
Päritoluriik CN
Harmoneeritud süsteemi kood 8526 9200 00
Paigaldusviis Süvistatud paigaldus (krohvi)
Siinisüsteem KNX No
Raadiosageduslik siinisüsteem Yes
Siinisüsteem Powernet No
Kinnitusviis Klamberpaigaldus
Muud siinisüsteemid Muul viisil
Siinisüsteem LON No
Kaitseaste (IP) IP20
Toimepunktide arv 1
Siinisüsteem KNX radio No
Raadiosageduslik, kahesuunaline Yes
Sisseehitatud paigalduskarbi vähim sügavus 18 mm

Pakendamise üksikasjad

Pakkimistase 1 4010312326015, 4010312326015
Pakkimistase 2 4010312326015
Pakkimistase 3 4010312326015

Allalaadimised

Toote lehe süvalink

Kirjeldus

Bus pushbutton coupler FTS61BTK/8 for 8 conventional pushbuttons for connection to FTS14TG pushbutton gateways by 2-wire pushbutton bus. Only 0.2 watt standby loss. For installation. 45mm long, 45mm wide, 18mm deep. Up to 30 bus pushbuttons and/or bus pushbutton couplers FTS61BTK/8 devices can be connected to the BP and BN terminals of a pushbutton gateway FTS14TG. The permitted total line length is 200m. The RLC device enclosed with the FTS14TG must also be connected to the terminals BP and BN on the bus switch or pushbutton bus coupler furthest away. A voltage of 29V DC is supplied to the connected FTS61BTK/8 over a 2-wire pushbutton bus which is also used for data transfer. Please use only conventional bus or telephone lines. Up to four conventional pushbuttons T1-T4 can be connected to the 15cm long connecting cables. Each opposite pole is T0. The connecting cables can be extended up to 2m. Caution: Do not apply any voltage. The pairs T1/T3, T2/T4, T5/T7 and T6/T8 can be defined as direction pushbuttons. Connect the bus to BP and BN. Make sure the polarity is correct.