Registruokitės, kad atrakintumėte savo išskirtines B2B kainas ir pradėtumėte apsipirkinėti. Užsiregistruokite dabar!

Powerline repeater

Yra sandėlyje: Ne Pardavėjo atsargos: Ne Minimalus užsakymo kiekis: 1

Kaina (be PVM):

83,29 €

Ši kaina galioja iki 31.12.24

EAN: 4010312324103

MPN: 31000030

Pakuotė: 1

Technical Information

Prekės būklė	Nauja
Gamintojo pavadinimas	Powerline repeater
Prekės ženklas	ELTAKO
Kategorijos	Jutikliai
Kilmės šalis	CN
Suderintos sistemos kodas	8526 9200 00
Nominali įtampa	230 V
Montavimo metodas	Apatinis sluoksnis (tinko)
EIB / KNX magistralės sistema	No
Magistralės sistemos radijo dažnis	No
„Powernet“ magistralės sistema	Yes
Kitos maršrutinės sistemos	Nėra
LON magistralinė sistema	No
Saugos laipsnis (IP)	IP20
KNX radijo magistralės sistema	No

Pakavimo informacija

Pakavimo lygis 1	4010312324103, 4010312324103
Pakavimo lygis 2	4010312324103
Pakavimo lygis 3	4010312324103

Atsisiuntimai

Gilios nuorodos į produkto puslapį

Aprašymas

Powerline repeater. 53x43mm, 25mm deep for mounting in 58mm switch boxes. Standby loss only 0,5 watt. The repeater supports greater ranges. With cable lengths of >300m the repeater is normally located in a distributor between the sensor and the actuator. The repeater repeats commands from sensors with the same address g, e. Feedback messages from actuators are not repeated. Two rotary switches are located on the front to assign addresses: The left-hand rotary switch determines the group address g with 16 alphanumeric digits from A to P. The right-hand rotary switch determines the element address e with 16 numerical values. Above it is a slide switch which is a configuration switch with positions 0, 1 and 2. Position 0: Central commands are repeated irrespective of the repeater’s e address. With address g, e=0, only central commands are repeated. Position 1: With address g, e=0 at the repeater, all commands of group g are repeated. Position 2: Unassigned. All entries and configurations can also be accessed via the mains using the Sienna Professional PC software. Addresses can be changed live or without voltage. On the left of the rotary switches is a red LED to display all activities. Next to that is the Reset button and to the right of that is Service Pin (P). The terminals located above are plug-in terminals for conductor cross-sections of 0.2mm² to 1.5mm².