Reģistrējieties, lai atbloķētu savas ekskluzīvās B2B cenas un sāktu iepirkties. Reģistrējieties tagad!
Powerline repeater image 1
ELTAKO

Powerline repeater

Ir noliktavā: Nē Piegādātāja krājumi: Nē Minimālais pasūtījuma daudzums: 1
Cena (bez PVN):
83,29 €
Šī cena ir spēkā līdz 31.12.24
EAN: 4010312324103
MPN: 31000030
Iepakojums: 1

Technical Information

Preces stāvoklis Jauns
Ražotāja nosaukums Powerline repeater
Zīmols ELTAKO
Kategorijas Sensori
Izcelsmes valsts CN
Harmonizētās sistēmas kods 8526 9200 00
Nominālais spriegums 230 V
Montāžas metode Iebūvējams vienā līmenī (apmetums)
Autobusu sistēma KNX No
Autobusu sistēmas radio bieži No
Autobusu sistēma Powernet Yes
Citas autobusu sistēmas Nav
Autobusu sistēma LON No
Aizsardzības pakāpe (IP) IP20
Autobusu sistēma KNX radio No

Iepakojuma informācija

Iepakojuma līmenis 1 4010312324103, 4010312324103
Iepakojuma līmenis 2 4010312324103
Iepakojuma līmenis 3 4010312324103

Lejupielādes

Links uz ražotāju mājaslapu

Apraksts

Powerline repeater. 53x43mm, 25mm deep for mounting in 58mm switch boxes. Standby loss only 0,5 watt. The repeater supports greater ranges. With cable lengths of >300m the repeater is normally located in a distributor between the sensor and the actuator. The repeater repeats commands from sensors with the same address g, e. Feedback messages from actuators are not repeated. Two rotary switches are located on the front to assign addresses: The left-hand rotary switch determines the group address g with 16 alphanumeric digits from A to P. The right-hand rotary switch determines the element address e with 16 numerical values. Above it is a slide switch which is a configuration switch with positions 0, 1 and 2. Position 0: Central commands are repeated irrespective of the repeater’s e address. With address g, e=0, only central commands are repeated. Position 1: With address g, e=0 at the repeater, all commands of group g are repeated. Position 2: Unassigned. All entries and configurations can also be accessed via the mains using the Sienna Professional PC software. Addresses can be changed live or without voltage. On the left of the rotary switches is a red LED to display all activities. Next to that is the Reset button and to the right of that is Service Pin (P). The terminals located above are plug-in terminals for conductor cross-sections of 0.2mm² to 1.5mm².