Registreeru, et avada oma eksklusiivsed B2B hinnad ja alustada ostlemist. Registreeru kohe!
Powerline repeater image 1
ELTAKO

Powerline repeater

Laos: Ei Hankija laovaru: Ei Minimaalne tellimuse kogus: 1
Hind (ilma KM-ta):
83,29 €
Hind kehtib kuni 31.12.24
EAN: 4010312324103
MPN: 31000030
Pakend: 1

Technical Information

Toote seisukord Uus
Tootja nimi Powerline repeater
Bränd ELTAKO
Kategooriad Andurid
Päritoluriik CN
Harmoneeritud süsteemi kood 8526 9200 00
Nimipinge 230 V
Paigaldusviis Süvistatud paigaldus (krohvi)
Siinisüsteem KNX No
Raadiosageduslik siinisüsteem No
Siinisüsteem Powernet Yes
Muud siinisüsteemid Puudub
Siinisüsteem LON No
Kaitseaste (IP) IP20
Siinisüsteem KNX radio No

Pakendamise üksikasjad

Pakkimistase 1 4010312324103, 4010312324103
Pakkimistase 2 4010312324103
Pakkimistase 3 4010312324103

Allalaadimised

Toote lehe süvalink

Kirjeldus

Powerline repeater. 53x43mm, 25mm deep for mounting in 58mm switch boxes. Standby loss only 0,5 watt. The repeater supports greater ranges. With cable lengths of >300m the repeater is normally located in a distributor between the sensor and the actuator. The repeater repeats commands from sensors with the same address g, e. Feedback messages from actuators are not repeated. Two rotary switches are located on the front to assign addresses: The left-hand rotary switch determines the group address g with 16 alphanumeric digits from A to P. The right-hand rotary switch determines the element address e with 16 numerical values. Above it is a slide switch which is a configuration switch with positions 0, 1 and 2. Position 0: Central commands are repeated irrespective of the repeater’s e address. With address g, e=0, only central commands are repeated. Position 1: With address g, e=0 at the repeater, all commands of group g are repeated. Position 2: Unassigned. All entries and configurations can also be accessed via the mains using the Sienna Professional PC software. Addresses can be changed live or without voltage. On the left of the rotary switches is a red LED to display all activities. Next to that is the Reset button and to the right of that is Service Pin (P). The terminals located above are plug-in terminals for conductor cross-sections of 0.2mm² to 1.5mm².