Self-learning mains disconnection relay, 1 NO contact 16A
Цена на складе (без НДС):
49,73 €
Цена действительна до 2024-12-31
Цена за м:
49,73 €
EAN: 4010312203255
MPN: 22100231
Наш склад:
Нет
Запасы поставщика:
Нет
За упаковку:
1
За коробку:
1
За поддон:
N/A
Технические данные
| Состояние товара | Новый |
| Название производителя | Self-learning mains disconnection relay, 1 NO contact 16A |
| Бренд | ELTAKO |
| Категории |
Реле |
| Страна происхождения | CN |
| Код гармонизированной системы | 8536 5080 00 |
| Способ крепления | DIN-рейка |
| Встроенная глубина | 26 mm |
| Номинальный ток | 10 A |
| Номинальное напряжение | 230 V |
| Номинальная частота | 50 Hz |
| Ширина в количестве модульных интервалов | 3 |
| Пороговый ток включения | 20 mA |
| Макс. ток переключения (cos phi = 0,6) | 16 A |
| Макс. нагрузка лампы накаливания | 2300 W |
| Макс. нагрузка люминесцентная лампа | 500 VA |
| Макс. нагрузка люминесцентная лампа (двойная схема) | 1000 VA |
| Макс. нагрузка люминесцентная лампа (с параллельной компенсацией) | 500 VA |
| Степень защиты (IP) | IP20 |
| Мониторинг напряжения | DC |
Сведения об упаковке
| Уровень упаковки 1 | 4010312203255, 4010312203255 |
| Уровень упаковки 2 | 4010312203255 |
| Уровень упаковки 3 | 4010312203255 |
Downloads
Описание
1 NO contact not potential free 16A/250V AC. Self-learning. 230V LED lamps up to 200W, incandescent lamp load 2300W. Standby loss 0.8 watt only. Modular device for DIN EN 60715 TH35 rail mounting. 1 module = 18mm wide and 58mm deep. 230V supply voltage and switching voltage. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. The FR12-230V mains disconnection relay disconnects the power supply once all series connected loads are turned off, thus preventing any electromagnetic interference fields from occurring. Small loads up to 200mA, are acceptable and, once major loads are disconnected, they do not prevent field disconnection. The limit is taught-in automatically by the FR12 using a patented method so you need not set the limit manually. Loads drawing more than 200mA are consistently defined as loads which should cause the line power to be connected. As long as no major load is turned on, one pole of the monitored circuit remains isolated from the mains. Neutral and earth are connected continuously to avoid acting as an aerial. A DC voltage with an extremely low residual ripple is applied for monitoring. Therefore, it is prohibited to bridge the relay contact, which would ultimately cause device failure. When a load is turned on, the mains disconnection switch connects the monitored phase after approx. 1 sec and the LED lights red.