Switching relay, 1 CO contact 16A

In stock: No Vendor stock: No Minimal order quantity: 1

Price (excl. VAT):

36,50 €

This price is valid until 31.12.24

EAN: 4010312205365

MPN: 22001601

Package: 1

Technical Information

Item condition	New
Manufacture name	Switching relay, 1 CO contact 16A
Brand	ELTAKO
Categories	Relays
Country of origin	CN
Harmonized System Code	8536 4900 00
Mounting method	DIN rail
Function	Partially electronic
Built-in depth	58 mm
Rated current	16 A
Width in number of modular spacings	1
Control voltage 1	230-8 V
Type of control voltage 1	AC/DC
Frequency control voltage 1	50 Hz
Voltage type of supply voltage	AC
Supply voltage	250 V
Max. switching current (cos phi = 0.6)	4 A
Max. incandescent lamp load	2000 W
Max. load fluorescent lamp	1000 VA
Max. load fluorescent lamp (Duo circuit)	1000 VA
Max. load fluorescent lamp (parallel compensated)	500 VA
Number of contacts as normally closed contact	0
Number of contacts as normally open contact	0
Number of contacts as change-over contact	1

Packing details

Packing level 1	4010312205365, 4010312205365
Packing level 2	4010312205365
Packing level 3	4010312205365

Downloads

Deep link product page

Description

1 CO contact potential free 16A/250V AC. 230V LED lamps up to 200W, incandescent lamp load 2000W. No standby loss. Modular device for DIN-EN 60715 TH35 rail mounting. 1 module = 18mm wide, 58mm deep. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. Universal control voltage 8 to 230V UC. Low control power demand, therefore substantially less heat is generated. Integrated free-wheeling anti-surge diode (A1 = +, A2 = -). Safe disconnection to VDE 0106, Part 101. Therefore, these devices can also be used as coupling relays. By using a bistable relay coil power loss and heating is avoided even in the on mode. The relay contact can be open or closed when putting into operation. It will be synchronised at first operation. This relay is not suitable to feed back the switching voltage signal of a dimmer switch. Use only relays ESR12DDX-UC, ESR12NP-230V+UC or ESR61NP-230V+UC for this purpose. The electronics does not have an internal power supply and therefore no standby loss. The microcontroller is activated when the control contact closes. This switches the bistable relay to the correct direction. The bistable relay switches back either when the control contact opens or when the control voltage falls.