DALI relay module 8A for flush-mounted box (DT7)

In stock: No Vendor stock: No Minimal order quantity: 1

Price (excl. VAT):

123,01 €

This price is valid until 31.12.24

EAN: 4010312324035

MPN: 33000007

Package: 1

Technical Information

Item condition	New
Manufacture name	DALI relay module 8A for flush-mounted box (DT7)
Brand	ELTAKO
Categories	Sensors
Country of origin	CN
Harmonized System Code	8542 3190 00
Mounting method	Flush mounted (plaster)
Rated current	10 A
Output power	1000 W
Rated operating voltage	230 V
Bus system KNX	No
Bus system radio frequent	No
Bus system Powernet	No
Max. switching power	1000 W
With bus connection	Yes
Max. number of switching contacts	1
Max. switching current	8 A
Other bus systems	Other
Bus system LON	No
Suitable for C-load	No
Different phases connectable	No
Local operation/hand operation	No
Degree of protection (IP)	IP20
With LED indication	No
Modular expandability	No
Bus system KNX radio	No
Radio frequent bidirectional	No
Bus module detachable	No
Max. switching power LED	1000 W

Packing details

Packing level 1

4010312324035, 4010312324035

Downloads

Deep link product page

Description

Module to control a relay contact over the DALI bus (DT7) for luminary installation and flush-mounted box. 59x33x15mm. Protection class IP20. DALI current consumption 2.7mA. Compact relay module for direct control of 230V loads over DALI. Loads without DALI input are easily integrated in a DALI circuit. Loads can be switched on/off by DALI commands. The device function complies with the standard for DALI Device Type 7 – switching function (as of Firmware 2.0). Adjustable characteristic for power-up and bus power failure. The DALI RM8 is powered over the DALI bus. No additional power supply is required. Zero passage switch-on. The module represents a bus user and is therefore addressable. Configuration via DALI Cockpit PC software. DALI functions and command set: The DALI RM8 can integrate loads on the DALI bus and can then switch them on/off. The DALI RM8 is a control device for non-dimmable loads based on the DALI specifications in IEC 62386-208 (Device Type 7). Accordingly, the switch characteristic is determined by comparing the virtual dim level (VDAP) with 4 switching thresholds. The virtual dim level (VDAP) corresponds to the dim level of a DALI electronic ballast with its corresponding characteristics (limited by MINLEVEL and MAXLEVEL, dimming speed limited by fade time and fade rate). There are 2 switching thresholds in each dimming direction and they are used for comparison with the virtual dim level. Only the applicable switching threshold for the current virtual dimming direction is evaluated. A threshold with the value MASK is inactive and is not used in the comparison. Switch-on/off delays can be implemented with fading. The DALI RM8 is powered from the DALI bus. The relay response to a bus power failure can be configured by the SystemFailureLevel (no change, ON or OFF, factory setting: ON). The power-on response after applying bus power can be set with PowerOnLevel.