Impulse switch, 2 NO contacts 16A

In stock: No Vendor stock: No Minimal order quantity: 1

Price (excl. VAT):

37,11 €

This price is valid until 31.12.24

EAN: 4010312108048

MPN: 21200002

Package: 1

Technical Information

Item condition	New
Manufacture name	Impulse switch, 2 NO contacts 16A
Brand	ELTAKO
Categories	Relays
Country of origin
Harmonized System Code	8536 5080 00
Mounting method	DIN rail
Function	Electronic switch
Built-in depth	58 mm
Width in number of modular spacings	1
Control voltage 1	8-230 V
Control voltage 2	230 V
Type of control voltage 1	AC/DC
Type of control voltage 2	AC
Frequency control voltage 1	50 Hz
Frequency control voltage 2	50 Hz
Suitable for manual operation	No
Max. switching current (cos phi = 0.6)	4 A
Max. incandescent lamp load	2000 W
Max. load fluorescent lamp	1000 VA
Max. load fluorescent lamp (Duo circuit)	1000 VA
Max. load fluorescent lamp (parallel compensated)	500 VA
Rated switch current	16 A
Number of contacts as normally closed contact	0
Number of contacts as normally open contact	2
Number of contacts as change-over contact	0

Packing details

Packing level 1	4010312108048, 4010312108048
Packing level 2	4010312108048
Packing level 3	4010312108048

Downloads

Deep link product page

Description

2 NO contacts potential free 16A/250V AC. 230V LED lamps up to 200W, incandescent lamp load up to 2000W. No standby loss. Modular device for DIN-EN 60715 TH35 rail mounting. 1 module = 18mm wide, 58mm deep. Either universal control voltage 8 to 230V UC at the control input +A1/A2 or 230V with glow lamp current up to 5mA at the control input (L)/-A2 (N). The simultaneous use of two potentials at the control inputs is not permitted. Very low switching noise. No permanent power supply necessary, therefore no standby loss. State-of-the-art hybrid technology combines advantages of nonwearing electronic control with high capacity of special relays. By using a bistable relay coil power loss and heating is avoided even in the on mode. The relay contact can be open or closed when putting into operation. It will be synchronised at first operation. Same terminal connection as the electromechanical impulse switch S12-200-. Maximum current across both contacts 16A for 230V. If this impulse switch is in a circuit, which is monitored by a FR12-230V mains disconnection relay, no additional base load is required. However, the monitoring voltage of the FR12-230V must be set to max. The electronics does not have an internal power supply and therefore no power is consumed in any contact position. A control current flows only during a short control impulse of 0.2 seconds. This activates the microcontroller, reads the last switching state from the non-voltage memory, switches the bistable relay to its opposite state accordingly and rewrites the new switching state to memory.