Powerline actuator 2 channels with 2 sensor inputs

In stock: No Vendor stock: No Minimal order quantity: 1

Price (excl. VAT):

94,43 €

This price is valid until 31.12.24

EAN: 4010312316672

MPN: 31200001

Package: 1

Technical Information

Item condition	New
Manufacture name	Powerline actuator 2 channels with 2 sensor inputs
Brand	ELTAKO
Categories	Sensors
Country of origin	CN
Harmonized System Code	8526 9200 00
Mounting method	Flush mounted (plaster)
Rated current	5 A
Output power	1000 W
Rated operating voltage	230 V
Bus system KNX	No
Bus system radio frequent	No
Bus system Powernet	Yes
Max. switching power	1000 W
With bus connection	Yes
Max. number of switching contacts	2
Max. switching current	5 A
Other bus systems	None
Bus system LON	No
Suitable for C-load	Yes
Different phases connectable	No
Local operation/hand operation	Yes
With LED indication	Yes
Modular expandability	No
Bus system KNX radio	No
Radio frequent bidirectional	No
Bus module detachable	No
Min. depth of built-in installation box	25 mm

Packing details

Packing level 1	4010312316672, 4010312316672
Packing level 2	4010312316672
Packing level 3	4010312316672

Downloads

Deep link product page

Description

Powerline actuator with 2 channels. 53x43mm, 25mm deep for mounting in 58mm switch boxes. Used as impulse switch or relay. 1+1 NO contacts not potential free 5A/250V AC, incandescent lamps 1000 watts. 2 sensor inputs with internal low voltage. Standby loss only 0,5 watt. To control and switch at the same place. Use only potential free switching elements. Internal low voltage applied to the sensor inputs. Two rotary switches are located on the front for address assignment: The left rotary switch defines the group address g with 16 alphabetical values from A to P. The right rotary switch defines the element address e with 16 numerical values from 0 to 15. Above it is a slide switch which acts as a configuration switch with positions 0, 1 and 2. Position 0: Sensor inputs function as pushbuttons (impulse switches). Position 1: Sensor input functions as NC contact (relay). Position 2: A change-over switch is evaluated as a pushbutton. All entries and configurations can also be accessed via the mains using the PC software SIENNA Professional. This means that another configuration can also be set that is not available via the rotary switches: Position 3: Sensor input acts as NO contact (relay inverse). To the left of the rotary switches is a red LED which indicates all activities. Next to it is a reset pushbutton and to the right of that is a service pin. For functions, please refer to the operating instructions. The terminals located above are plug-in terminals for conductor cross-sections of 0.2mm² to 1.5mm². Next to them are three wires with wire end-sleeves for the two control inputs with internal low voltage.